Poly bushes for the Manta A series
Useful tip provided by TJ Motorsport:
After a little bit of investigation it looks like some of the Manta B /
Kadett C / Chevette bushes are compatible.
I have listed them below:
Manta A same as Manta B
Front End Bush - Strut bar to chassis mount (Possibly SPF1753 which is listed as
front lower tie (crossmember brace) outrigger bar to chassis leg bush assy and
stainless tube and SPF1753W is flat washer which replaces the original bevelled
washer)
Bush - Upper control arm - front (SPF1553)
Bush - Upper control arm - rear (being redevloped for me by Superflex at the mo)
(SPF1552)
Rear End Bush - Crossbeam to chassis (possibly panhard rod? Are they fitted, if
so SPF0030 and SPF0030T)
Bush - slider rod kit (not available at the mo as poly replacement)
Bush - trailing arm to chassis - front (also available as a rosejointed arm -
developed for me) (SPF0402)
Bush - trailing arm ro rear axle - rear (SPF0403)
Bush - rubber segment rear axle extension to cross beam (not available as poly)
diameter 50mm
Bush - as above 40mm
Bush - rubber stop centre bearing (not available as poly)
Bush - sway bar (anti roll bar) to rear axle
Bush - sway bar to chassis (SPF1812/18 which is for diameter 18mm)
Rear centre propshaft mount bush and stainless steel tube SPF0403 again?
They are the only ones that are listed as the same. If these are of any use
please email me as they are available for immediate despatch.
Timothy Jones - TJ Motorsport
Email with any queries or orders to................... tjmotorsport@btinternet.com